Kickflip Skateboard | Skateboard Tricks & Tips

Buying new Bearings

My K2 skates have 8-mm, TwinCam, ABEC-1, double-shielded bearings with the following inscribed on the casings:

TwinCam

ABEC-1

608 ZZ

Normally, the manufacturer or brand doesn’t make a lot of difference within the three categories of shielded, serviceable bearings, shielded, serviceable bearings with pop-up caps, and sealed, non-serviceable bearings. A bearing size of 8mm and the 608 designation are fine for recreational, inline skaters. The ABEC rating is another story!

ABEC Bearing

ABEC-1, 3, and 5 are the most common bearings that come with inline skates, as well as the newer ABEC-7s, which are gaining in popularity. Whether a skater can go faster with ABEC-5 bearings versus ABEC-1 bearings has never been proven, scientifically or otherwise.

Furthermore, the higher precision may not make a significant difference for the recreational skater who travels in the 10 to 20 mph range. The average skater doesn’t require a higher-rated bearing because the difference in performance is so minimal that it would only become apparent at speeds an inline skater never attains.

In addition, the higher precision eventually deteriorates down to ABEC-3 or 1 due to dust, dirt, and regular wear and tear. To increase your skating speed, you’d be better off to improve your technique and learn how to cut down on wind resistance. These are proven ways to make you a faster and more efficient skater.

Servicing your Bearings

Inline skate bearings usually come in sets of four to eight. Before you head out to your favorite sporting goods store, write down the information that’s shown on the outer shields of your bearings. Don’t forget to flip the bearing over and include the text that’s inscribed on the other side.

Skateboard Bearing

If you’re happy with the original bearings that came with your skates or the last set you installed, by all means buy the same bearings. If you have serviceable bearings like TwinCams or YAKs and you don’t mind doing your own cleaning and lubrication than you may want to stick with the double-shielded type, especially if they are the Original Equipment Manufacturer (OEM) that your skate manufacturer recommends.

On the other hand, if you have non-serviceable or sealed bearings and are squeamish about doing your own cleaning and lubrication, even periodically, you may want to stick with this type of bearing and just replace them when they need to be changed.

In addition, if you have shielded bearings with pop-out caps, like Powell Swiss or Black Hole brands, and like them for their ease of maintenance, it’s probably best to go with this kind of bearing again.